#Repetier server webcam how to

# Configuration for /etc/init.d/octoprint # The init.d script will only run if this variable non-empty. Nginx, for later use with more servers and also for sake of experimenting. Haproxy, I've preferred skipping over that part and setting up my own While in the official setup page you'll find that they used I personally recommend using some reverse proxy at least. The first and the third step and go to the OctoPrint setup directly. Port 5000, or you're brave enough to set it to the port 80 you can skip Note that if you want only the print server and you don't care that uses the Instructions for already running raspberries, perfect! Keep in mind that this isĭone on an already working Raspberry Pi with static IP and all that stuff. Want to lose everything in my current server, so that option was discarded.įinally, I've found OctoPrint, and installation Printing server, but they offer (apparently) only the pre-built image. The second option, Astroprint seems very cool, and a perfect fit for my local Suite, maybe some day I'll give it a try. The problem is that there was a paid plan that offers the full The options were:įor the first, Repetier Server offers a lot of stuff, and I like the interface,Īs I've been using for a while in the past Repetier Host (Which The point is that, I wanted aģD printing server that supported webcam.

#Repetier server webcam how to

Time to time, I may post how to do it some day.

I'veīeen using it for a while as Gitlab CI/CD Some time ago, I've purchased a Raspberry Pi3 in Amazon.